DIY, how to, kitchen, making do

Home hack: Never Refill the Dish Soap Dispenser Again!

03/29/2021
In-Sink Soap Dispenser Hack - Never Refill It Again!

When we gave the kitchen a facelift and installed a new countertop and sink, I was excited to add a built-in dish soap dispenser. As a minimalist at heart, I looked forward to not having a bottle of dish soap sitting on the counter next to the sink. How easy it will be to push the integrated pump and dispense dish soap directly into the sink! And it really is convenient … until the dispenser bottle under the sink needs to be refilled. When that happens, all thoughts of minimalism and daily convenience are replaced by frustration as I climb under the sink to remove and then replace the little bottle that seems to only hold a few dozen pumps of soap. Removing that little bottle is easy, of course. Screwing the bottle back into the fitting under the sink? That’s some sort of torture!

Well, my days of climbing under the sink are over! With the addition of a simple rubber hose, I can replace that tiny dispensing bottle with a giant jug of dish soap. Screw that little bottle! Or, rather, never screw that bottle back into the sink again! And all it took was a few feet of latex tubing. Specifically, latex tubing with 1/4″ inner diameter and 3/4″ exterior diameter – found at your local hardware store. I purchased a 10 foot coil of tubing because that’s what I found on the rack at the Lowes where I was shopping. I used only 3-ish feet of the tubing but am happy to have enough leftover to fix the pump back at the city apartment, too. If you can buy your latex tubing by the foot, get only as much as you need. But if you happen to buy extra, offer to use the remainder that save your friends from screwing the bottle.

But before you can go out and help your friends, you’ll need to know how to do it, right? OK, so here goes…

Standing at the sink, remove the pump. It should be as easy as pulling up on the pump – the entire thing, the pump and existing tube, should remove easily. Now, slip one end of the latex tubing over the end of the soap pump tube.

Place the pump, with tube attached, in the receptacle in the sink. Now, let this be the last time you climb under the sink. While you’re down there, snip the end of the latex tubing where it meets the bottom of the under-sink cabinet.

Remove the cap from that extra large bottle of dish soap that you’ve been using to refill the measly little bottle that came with the dispenser. Place the latex tubing into that large bottle of dish soap.

And there you have it. In just a few simple steps you’ve created a workaround that will eliminate the need to ever refill that little soap pump dispenser bottle again! It may take a number of pumps before the soap works its way through the latex tube and out the dispenser, but once it does you’re good to go.

Happy washing!

You Might Also Like

No Comments

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.